GitLab

Following patch adds support for that.

Corresponding to flashrom svn r283 and coreboot v2 svn r3399.
Signed-off-by: Rudolf Marek <r.marek@assembler.cz>
Acked-by: Peter Stuge <peter@stuge.se>

It is similar with few documented exceptions to ICH7 SPI controller.

Corresponding to flashrom svn r282 and coreboot v2 svn r3398.
Signed-off-by: Rudolf Marek <r.marek@assembler.cz>
Acked-by: Peter Stuge <peter@stuge.se>

* ICH7 SPI support
* fix some variable names in ichspi.c (Offset -> offset)
* Dump ICH7 SPI bar with -V
* Improve error message in case IOPL goes wrong. (It might not even be an IOPL)

Corresponding to flashrom svn r278 and coreboot v2 svn r3393.
Signed-off-by: Stefan Reinauer <stepan@coresystems.de>
Acked-by: Peter Stuge <peter@stuge.se>

Preparation for a probe optimization patch. This patch does not change any
functionality. spi_probe_rdid was tested to still work on my M57SLI rev 2.

The idea is to have error checks return error immediately when something
fails, rather than having code inside an if block where the condition
tests for success.

This means: Less indentation, more clear what the code is checking.

Corresponding to flashrom svn r272 and coreboot v2 svn r3386.
Signed-off-by: Peter Stuge <peter@stuge.se>
Acked-by: Ward Vandewege <ward@gnu.org>

This is done by using the generic SPI interface.

Corresponding to flashrom svn r239 and coreboot v2 svn r3325.
Signed-off-by: Dominik Geyer <dominik.geyer@kontron.com>
Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>

Corresponding to flashrom svn r237 and coreboot v2 svn r3323.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Peter Stuge <peter@stuge.se>

Add support for the JEDEC RES (Read Electronic Signature and Resume from
Powerdown) SPI command to identify older SPI chips which can't handle
JEDEC RDID.

Since RES gives a one-byte identifier which is shared among many
different vendors and even different sizes, we want to match RES as a
last resort if RDID returns 0xff 0xff 0xff.

Corresponding to flashrom svn r235 and coreboot v2 svn r3320.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Peter Stuge <peter@stuge.se>

This is a heavily reworked version of a patch by Fredrik Tolf, which was
Signed-off-by: Fredrik Tolf <fredrik@dolda2000.com>

Flash chips which can be detected by JEDEC probe routines all have
vendor IDs with correct parity. Use a parity check as additional hint
whether a vendor ID makes sense. Note: Device IDs have no parity
requirements whatsoever.

Corresponding to flashrom svn r231 and coreboot v2 svn r3308.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Peter Stuge <peter@stuge.se>

No behavioural changes, but greatly improved SPI abstraction.

Corresponding to flashrom svn r229 and coreboot v2 svn r3305.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Peter Stuge <peter@stuge.se>

This patch has no code changes.

Corresponding to flashrom svn r228 and coreboot v2 svn r3302.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Peter Stuge <peter@stuge.se>

In theory, this patch has no behaviour changes.

Corresponding to flashrom svn r227 and coreboot v2 svn r3301.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Peter Stuge <peter@stuge.se>

This paves the way to have a fully generic generic_spi_command without
knowledge about any SPI controller.

The third step would be calling SPI controller functions via a function
pointer.

Corresponding to flashrom svn r224 and coreboot v2 svn r3296.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Peter Stuge <peter@stuge.se>

This is a very early step toward cleaning up SPI code in flashrom.

Corresponding to flashrom svn r223 and coreboot v2 svn r3295.
Signed-off-by: Peter Stuge <peter@stuge.se>
Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>

Some vendors like Programmable Micro Corp (PMC) need this. Both the
serial and parallel flash JEDEC detection routines would benefit from a
parity/sanity check of the vendor ID. Will do this later.

Add support for the PMC Pm25LV family of SPI flash chips.

Corresponding to flashrom svn r191 and coreboot v2 svn r3091.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Chris Lingard  <chris@stockwith.co.uk>

Minor formatting changes.

Corresponding to flashrom svn r184 and coreboot v2 svn r3069.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Harald Gutmann <harald.gutmann@gmx.net>

readcnt==0 saves 10 seconds with the unconditional 10us delay, reducing
programming time for SST25VF016B to 40-45 secs.

Corresponding to flashrom svn r183 and coreboot v2 svn r3068.
Signed-off-by: Ronald Hoogenboom <hoogenboom30@zonnet.nl>
Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>

Support SPI flash chips bigger than 512 kByte sitting behind IT8716F
Super I/O performing LPC-to-SPI flash translation.

Corresponding to flashrom svn r181 and coreboot v2 svn r3061.
Signed-off-by: Ronald Hoogenboom <hoogenboom30@zonnet.nl>
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>

Corresponding to flashrom svn r173 and coreboot v2 svn r3032.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Ronald G. Minnich <rminnich@gmail.com>

Pretty-print the chip status register (including block lock information)
for ST M25P family and Macronix MX25L family chips.

Corresponding to flashrom svn r168 and coreboot v2 svn r3026.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Corey Osgood <corey.osgood@gmail.com>

To make it easier to add new SPI chips to flashchips.c, rename functions
with multiple possible opcodes from linear numbering at the end (_1, _2)
to include the opcode at the end (_60, _c7).

That way, you only have to take a short look at the data sheet and
choose the right function by appending the opcode listed in the data
sheet. No functional changes.

Corresponding to flashrom svn r165 and coreboot v2 svn r3009.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Ward Vandewege <ward@gnu.org>

Detection was tested. Print status register before erase to help
debugging block locks.

Corresponding to flashrom svn r164 and coreboot v2 svn r3008.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Corey Osgood <corey.osgood@gmail.com>

Corresponding to flashrom svn r155 and coreboot v2 svn r2881.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Reinauer <stepan@coresystems.de>

This has been tested by Harald Gutmann <harald.gutmann@gmx.net> with a
MX25L4005 chip.

Corresponding to flashrom svn r154 and coreboot v2 svn r2876.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Reinauer <stepan@coresystems.de>

The first chip the code was tested and verified with is the Macronix
MX25L4005, but other chips should work as well. Timeouts are still
hardcoded to data sheet maxima, but the status register checking code is
already there. Thanks to Harald Gutmann for the initial code on which
this is loosely based.

Corresponding to flashrom svn r152 and coreboot v2 svn r2874.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Reinauer <stepan@coresystems.de>

Corresponding to flashrom svn r151 and coreboot v2 svn r2873.
Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de>
Acked-by: Stefan Reinauer <stepan@coresystems.de>

Corresponding to flashrom svn r147 and coreboot v2 svn r2863.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Reinauer <stepan@coresystems.de>

Corresponding to flashrom svn r146 and coreboot v2 svn r2858.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Reinauer <stepan@coresystems.de>