GitLab

The first byte of the flash chip was read at the start of the function
and later written back to address 0 if the flash chip was not identified
as SST28SF040, which means most of the time. This write caused corruption
of flash contents when verifying a SST49LF160C part.

Corresponding to flashrom svn r126 and coreboot v2 svn r2744.
Signed-off-by: Ed Swierk <eswierk@arastra.com>
Acked-by: Peter Stuge <peter@stuge.se>

Corresponding to flashrom svn r115 and coreboot v2 svn r2693.
Signed-off-by: Stefan Reinauer <stepan@coresystems.de>
Acked-by: Stefan Reinauer <stepan@coresystems.de>

* Give decent names to virt_addr and virt_addr_2
* add some comments
* move virtual addresses to the end of the struct,
  so they dont mess up the initializer.

Corresponding to flashrom svn r111 and coreboot v2 svn r2689.
Signed-off-by: Stefan Reinauer <stepan@coresystems.de>
Acked-by: Stefan Reinauer <stepan@coresystems.de>

  indent -npro -kr -i8 -ts8 -sob -l80 -ss -ncs *.[ch]

Some minor fixups were required, and maybe a few more cosmetic
changes are needed.

Corresponding to flashrom svn r108 and coreboot v2 svn r2643.
Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de>
Acked-by: Uwe Hermann <uwe@hermann-uwe.de>

Corresponding to flashrom svn r34 and coreboot v2 svn r2111.

Corresponding to flashrom svn r19 and coreboot v2 svn r1486.

Corresponding to flashrom svn r15 and coreboot v2 svn r1457.

Corresponding to flashrom svn r8 and coreboot v2 svn r1434.

Corresponding to coreboot v1 svn r873.

Corresponding to coreboot v1 svn r752.

 - switch to volatile everywhere
 - use myusec_delay instead of usleep

Corresponding to coreboot v1 svn r492.

Corresponding to coreboot v1 svn r489.