Mark 3COM "3C905B: Cyclone 10/100/BNC" as fully tested

Also do some random cleanups while I'm at it.

Corresponding to flashrom svn r567.
Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de>
Acked-by: Uwe Hermann <uwe@hermann-uwe.de>

flash.h

@@ -346,8 +346,8 @@ extern const struct board_info boards_bad[];
 #define EN_29F040A		0x7F04
 #define EN_29LV010		0x7F6E
 #define EN_29LV040A		0x7F4F	/* EN_29LV040(A) */
-#define EN_29F002T		0x7F92
-#define EN_29F002B		0x7F97
+#define EN_29F002T		0x7F92	/* Also EN29F002A */
+#define EN_29F002B		0x7F97	/* Also EN29F002AN */
 
 #define FUJITSU_ID		0x04	/* Fujitsu */
 #define MBM29F400BC		0xAB

flashrom.8

@@ -133,7 +133,7 @@ Specify the programmer device. Currently supported are:
 .sp
 .BR "* satasii" " (for flash ROMs on Silicon Image SATA/IDE controllers)"
 .sp
-.BR "* it87spi" " (for flash ROMs behind a IT87xx SuperI/O LPC/SPI translation unit)"
+.BR "* it87spi" " (for flash ROMs behind an ITE IT87xx Super I/O LPC/SPI translation unit)"
 .sp
 The dummy programmer has an optional parameter specifying the bus types it
 should support. For that you have to use the

nic3com.c

@@ -46,7 +46,7 @@ struct pcidev_status nics_3com[] = {
 	{0x10b7, 0x9006, PCI_NT, "3COM", "3C90xB: PCI 10BASE-T/10BASE2 (TPC)" },
 	{0x10b7, 0x900a, PCI_NT, "3COM", "3C90xB: PCI 10BASE-FL" },
 	{0x10b7, 0x905a, PCI_NT, "3COM", "3C90xB: PCI 10BASE-FX" },
-	{0x10b7, 0x9058, PCI_NT, "3COM", "3C905B: Cyclone 10/100/BNC" },
+	{0x10b7, 0x9058, PCI_OK, "3COM", "3C905B: Cyclone 10/100/BNC" },
 
 	/* 3C905C */
 	{0x10b7, 0x9200, PCI_OK, "3COM", "3C905C: EtherLink 10/100 PCI (TX)" },